Package includs:

1. Inverter ¡V 12V DC input
2. Cold Cathode Neon Tube Set
3. Light switch
4. Washer
5. Cut hole template sticker
6. Installation instruction sheet

Step-by-step installation instruction:

1. Turn off and unplug your computer from AC power source, Remove the case door.
2. Decide on location you want the light switch to be installed. Make sure that no obstruction inside the chassis where the switch is to be installed.
3. Mark the center of switch installation location and apply the cut hole template sticker. Place masking tape around the edges of cutting line to prevent scratching during the cutting process.
4. Cut or drill the hole for the light switch.
5. Disconnect two(2) quick disconnect terminals from the light switch.
6. Install the switch into the cut hole and use the included washer to fasten the light switch on to the case door.
7. Reconnect the quick disconnect terminals onto the light switch.
8. Decide on the location for the CCFL light tube; make sure the light and inverter can be installed on the desired location.
9. Plug the four-pin Molex connector to the matting connector from the power supply unit in the case.
10. Reinstall the case door and turn on the computer.